TM Systems

Mondi Syktyvkar HVAC: Less condensation, better working conditions via HVAC

by

mondi syktyvkarCase: Mondi Syktyvkar, Russia. HVAC for Pulp Dryer Building.

Goals

To improve the machine room ventilation in the pulp dryer building and in the control room. To prevent condensation on the inner roof especially during cold winter months with temperatures lower than -35˚C.

[Read more…]

Mondi Stambolijski Trim Handling: More efficiency needed, but no time for shut-down

by

Case: Mondi Stambolijski Bulgaria: Trim handling system for a winder.

Trim Handling System used in Stambolijski.
Typical Trimvac trim handling system

 

Goals

The customer’s trim conveying system was not efficient enough. The existing system was ejector-based. The winder was not able to run at full speed and the ejector air was blown to the pulper causing the area to become overpressurised. Additionally, the energy consumption was too high. [Read more…]

Ilim Group Bratsk Heat Recovery: Less energy loss in Siberian conditions

by

puristin 2Goals

Many leaks and lost energy in the old systems, how could we improve them? What is the right solution to minimize the losses considering the weather conditions range from -45 °C to +35 °C? Heat recovery.

[Read more…]

OKI: Key HVAC supplier to the world’s largest pulp and paper mill

by

150 modules are ready, set and go for APP OKI Pulp and Paper Mill.
150 modules are ready, set and go to OKI Pulp and Paper Mill, to-be the largest in the world.

Asia Pulp and Paper APP set particularly high standards for the ventilation system of the world’s largest pulp and paper mill, OKI, to be built in Indonesia. They were met by TM Systems’ HVAC system. TM Systems is one of the key suppliers in this massive project. [Read more…]

”We see clear energy savings”, says Pasi Lampinen, Stora Enso Imatra mills

by

 

kaukopaaCase: Stora Enso’s Imatra mills at Kaukopää wanted to improve the machine hall ventilation around the PK6 paper machine.

Goals

The investment aimed to improve the machine hall ventilation, to even out the temperature differences and to increase the performance of heat recovery in the ventilation. The goal was also to create savings in energy usage by decreasing the steam usage in supply air heating.

Testimonial by: Pasi Lampinen, production manager, Stora Enso, Imatra [Read more…]